I had to remake the front panel of the trailer, the previous one was 5mm too short.
I think my method of construction is: measure once, cut, test fit, swear, measure again, trim a bit, test again, swear some more, throw it out, cut a new piece, test yet again, swear profoundly, measure again, hack it a bit, whack it on, yell good enough!
I also ground down the front corners of the frame to round it for the front panel to fit. God bless the Dremel!
Not done up completely yet, have to dismantle the whole trailer for painting and chrome adhesive on the styrene. Also going to add a painted strip of styrene (or maybe ali) along the top and bottom of the front panel. Have a reefer unit on the way, so will mount when it arrives.
