Well, I did managed to get my robot to poop a little bit more plastic and this is where I'm at.
Over 30 hours of printing just for the hood, original has a flip forward hood and I'm replicating that with brass hinges and magnets to keep in place.
A little design error regarding the magnets; not enough material above the magnets so it didn't print, I'll guess it will be just filler and paint over it...
The roof is still just a test piece needs to be modified a little bit, work in progress.
The driver is just a forklift driver I found on Thingiverse, don't know yet if I'll use it.
Can't do much more until I order more plastic (which takes at least 2 weeks to arrive) and more parts show up.