Thread: Dragline Crawler Build
View Single Post
  #76  
Old 06-15-2015, 04:34 PM
Rvjimd's Avatar
Rvjimd Rvjimd is offline
Craftsman
  
Join Date: Dec 2012
Location: Des Moines, Iowa
Posts: 884
Rvjimd is on a distinguished road
Default Re: Dragline Crawler Build
Slip ring? Has anyone tried a DIY slip ring? I have repaired one on a in motion servo satellite reciever and I am thinking about trying it. I guess I haven't looked online yet to see how much they are and how it would fit into the UC?

One of the things with my particular install is that there "should be" a 1/4" shaft in the center of the bed that the upper house centers and pivots on. This way it matches the truck frame, in case I want to switch back to the highway truck chassis.

Jim
Last edited by Rvjimd; 06-15-2015 at 04:36 PM.
Reply With Quote