Thanks for the advices, Joe. I appreciate them and will give them a try at the next dig.
But due to a complete disassembling of the excavator this will take some time.
Disassembling for fixing issues , improvement and so on.
Til waiting for easter brunch with the family I've made the cables for the working lights on the monobloc.
Simple wires are bending in very unpredictable ways.
To tame them I've used a simple but effective method.
Whilst the hole procedure take care that the wires laying flat side by side.
Two single wires are bound with a very thin stainless wire
This thing pulled through a heat shrink tube.
After shrinking the wires get more stiffer and bends reproducable nice way