[jj650]

I didn't care for the high front stance with the springs mounted in the original chassis holes. I drilled new holes 5mm higher to mount the springs. This got the stance where i like it.





And added some spacers due to the spring width being slightly wider than the stock straight axle.



The washers were temporary, i made an aluminum spacer once i knew how much was needed.



And the front axle and springs bolted in place.







And in keeping with my cheap theme the easiest, cheapest way to put front drive wheels on is use the stock plastic inner rear dual wheel because it has the hex drive.





Now onto the cheapest way to drive that front axle.....