[RCP57]

I spent a couple of hours on this again late this afternoon. I can see why people convert these all the time. It is quite simple. Today's plan was to get it swinging and it went very easy. I machined the excavator's pieces to fit around the 360 servo providing a nice tight fit. I'm not sure what pitch the ring gear is but I was able to find a suitable pinion in my junk after a lot of searching. A couple of quick mods had it bolted to the servo and the house spinning! I'm not sure what I will tackle next. I will probably finish all of the stuff up top before buttoning up the track frames but we'll see.

https://youtu.be/D96ms9oTgSA






Thanks for looking.