And the night ending process, (with issues again!)
Milled this acetal rod to act as an all in one spacer between wheels and suspension arms.
After questioning my measurements a few times I cut the part. Well I now know why I was questioning my numbers.
Then numbers are good but I forgot to compensate for the darn size of tool!!!!!!! The axle is supposta encompass top and bottom of arms. Have to slide them into axle then the actual axle rod into place. It secures everything together. And yes it's a solid fixed no torsion axle, just the springs. I figure for model it will help keep load from rocking much. Don't know but it seems logical to me?