View Single Post
  #22  
Old 10-21-2019, 05:46 PM
agriRC agriRC is offline
Newbie
 
Join Date: Sep 2019
Location: Wales, UK
Posts: 18
agriRC is on a distinguished road
Default Re: Fully 3D printed John Deere 1/10 scratch build

Quote:
Originally Posted by ddmckee54 View Post
Regarding the 30mm or 50mm fan for the smoke unit. If it were me I'd go with a 50mm radial blower, like the kind used by 3D printers for filament cooling fans, instead of a 50mm axial fan. The radial blower will handle the higher back pressure you have in this system and the difference in airflow will be amazing.

Don
Yes good point, I will look into them. May allow me to slimline the design so I can fit more/bigger batteries under the bonnet.

Thank you

agriRC
Reply With Quote