[jerry56]

Well I ran into a weird problem.. I hooked everything up for a hot check before I closed it all up and I was cycling my blade up and down and my beacon came on... I shut it off and cycled my blade 3 or 4 times and it came back on... So I figured it was a bad beacon so I replaced it with a different one...same thing....so I changed the respective channels the blade and the beacon were on same thing so I changed the recvr. ...same thing.. I even changed transmitters....same thing cycle the blade 3 or 4 times and the beacon pops on.... So I changed the servo to a Hitec I had and the beacon stays off....I cycled the blade a dozen times and the beacon stayed off....So now I need to make a different mount since the servos were slightly different sizes... but now the Hitec servo horn is to short to get all the way out thru the grill with out rubbing..... So I guess I'll try another of the SPT servos and hope it's just this one that's causing the problem and not all of them...