Slewing bearing

[Machfab]

What are you scratch-build guys using for a slewing ring bearing on a 1/14 excavator? Any sources?
Thanks

[bigford]

all from rcbrmin there the slew ring, gear and pinion gear for the kat

http://www.rcbrmin.com/index.php?mai...roducts_id=769

http://www.rcbrmin.com/index.php?mai...roducts_id=662

http://www.rcbrmin.com/index.php?mai...roducts_id=779

[mcCracken15]

I just purchased one. Its great. I was pretty dissapointed when i found out their is no bearrings in it but it is still a good buy. Ended up chucking it up in the lathe cause it was about a half inch to tall.

[Busydad]

Torrington make some nice thrust bearings . Not certain if they would fit your application ..

[Machfab]

I think I will try a couple of thin section bearings and see how they perform.

[ptebbe]

I used a tapered bearing on the top (carries both radial and thrust load):
http://www.mcmaster.com/#standard-ba...rings/=122wlwm

And I used a regular ball bearing underneath. I machined aluminum bearing holders and screwed a 72t gear-ring onto the top one.

This might have been overkill, but it is super tight and it turns very smooth.
Paul

[SteinHDan]

ptebbe: Where did you get that 72t gear ring? Do you have a link? Thanks in advance! :-)


I also used a tapered bearing on my excavator, but I also had another opposite-facing tapered bearing for the bottom one so that the tapers combined where in a X shape. It got very sturdy, tight and rolls very well (details here)



Best regards,
Stein :-)