|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
What gear motor speed?
So guys what rpm do you guys run in your custom dozer projects?
I got to replace one in my dozer project and was like may get two new ones Instead of just one. Let me know. Right now I'm using 124 rpms and thing of going to 98 maybe 56 , what yell think? |
#2
|
||||
|
||||
Re: What gear motor speed?
On my Oliver I am using planetary gear motors at 52rpm, and I like to use the dual rate switch and slow down to about half that speed on full stick forward while pushing, then full speed to reverse.
Jim Last edited by Rvjimd; 05-23-2017 at 08:39 PM. Reason: 52 rpm |
#3
|
||||
|
||||
Re: What gear motor speed?
I think I'm pushing 25-30 rpm on final drive with the d11. Also depends on how big your sprocket is. But for a starting point, and smaller dozers run a little speeder.
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#4
|
||||
|
||||
Re: What gear motor speed?
Thanks guys I went to 98 rpm I was running 140rpm .
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|