|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Hard line problems.
I think this stuff only happens to me and hydraulic tech is spotty on the internet at best.
So ....... I made some hard lines to replace the really long hoses that go all the way around the excavator It was working fine but perfect because the pump needed a rebuild but now with the new brass hard lines it moves really slow and the bucket cyclinder dose t move at all! I used 3/32 lines and 1/16 fittings. Could the hard lines to small? There not blocked so help! |
#2
|
|||
|
|||
Re: Hard line problems.
It's very possible, especially since you state they worked fine before converting to hard lines!
|
#3
|
||||
|
||||
Re: Hard line problems.
Ya I rebuilt them with bigger lines and it work right again
|
#4
|
|||
|
|||
Re: Hard line problems.
Sweet! Good to know you got er working proper once more.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|