|
General Discussion A place to post off topic discussions. |
|
Thread Tools | Display Modes |
#41
|
||||
|
||||
Re: MORPOWER pump & valve
Hey Ed did you get a quote on the 6 spool valve ?
I recentley purchased one of their 3 spool and tried to remove one of the fittings ....seems they are pretty fragile as I broke one of the fittins off ..Wasnt alot of force either ..I wont dare to try another..I am thinking they were glued in for extra sealing because the small nipple left behind would not budge and had to be drilled and tapped out |
#42
|
||||
|
||||
Re: MORPOWER pump & valve
I would put better servos on these I had some finicky 1s . A hiteck 85MG fits
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#43
|
||||
|
||||
Re: MORPOWER pump & valve
Have you used the valves yet Steve? Opinions????
|
#44
|
||||
|
||||
Re: MORPOWER pump & valve
Yes in my compactor . I slightly modified them a bit . I bored the feed and return out to accept 5mm fittings also helps with the flow . I'm using the Jung pump with them turned down low ( it's more pump then needed but I had it ) the only issue was the servos seemed weak sometimes would not move or move partially . IMO , it's bulky for a small model but fits well with the Jung in the 825C ( just )
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#45
|
|||
|
|||
Re: MORPOWER pump & valve
|
#46
|
|||
|
|||
Re: MORPOWER pump & valve
can send me a hydraulic valve drawings?thank you!
|
#47
|
|||
|
|||
Re: MORPOWER pump & valve
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|