![]() |
|
Highway Trucks and Trailers On road trucks and trailers single and twin axle trucks. |
![]() |
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
![]()
Thanks for all that information, found it really helpful. I'll get extra clear and try different paints because I will be tinting the windows to hide the electronics. Not putting the seats and stuff, doubt I'll have room for them.
__________________
Not trolling anymore... To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#22
|
||||
|
||||
![]()
brian from exclusive make a whole back panel with a rear window
|
#23
|
|||
|
|||
![]()
Your welcome.
|
#24
|
|||
|
|||
![]()
__________________
Not trolling anymore... To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#25
|
|||
|
|||
![]()
Good work on the project, keep it up!!
|
#26
|
|||
|
|||
![]()
Started test fitting some parts that came in. Drop Visor from ebay, Rc4wd Grill, Steve's Bumper and Air Cleaners. Bodywork should be done by next week, so then the Garden square pete lights can be mounted. Figured I show something since Reg has posted the start of the box.
![]() ![]()
__________________
Not trolling anymore... To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Last edited by Kausekaos; 10-28-2015 at 02:18 PM. |
#27
|
||||
|
||||
![]()
Nice truck man, Where did you get the dump box I like it alot!
|
#28
|
||||
|
||||
![]() |
#29
|
|||
|
|||
![]()
__________________
Not trolling anymore... To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#30
|
|||
|
|||
![]()
The truck looks really good! So does the dump box Reg is doing for you, nice style. Should turn out to be a real nice truck. Are you going to have the dump bed painted or raw? What color are you going to paint the truck?
|
#31
|
|||
|
|||
![]()
Its going to be painted. The colors I'm thinking is silver and black. I have a paint scheme in mind.
__________________
Not trolling anymore... To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#32
|
|||
|
|||
![]()
That should look good. Keep the pictures coming.
|
#33
|
|||
|
|||
![]()
Is the construction trailer to pull behind the dump? Just saw it and was wondering. Did that with mine. The orange isn't that bad.
|
#34
|
|||
|
|||
![]()
Yes that trailer is going to be pulled behind this. Orange didn't match the paint scheme I have in mind. Was bored today so I was messing around with some stuff. Put the stacks on. Hope to have this ready before the Half round gets here.
![]() Then I cut the Aeromax sleeper off and put it on the King Rails just to see how it would look with the other box I have. ![]() ![]() Maybe I'll have shorter rails made or possibly do something like this. ![]()
__________________
Not trolling anymore... To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Last edited by Kausekaos; 11-02-2015 at 07:26 PM. |
#35
|
|||
|
|||
![]()
Sounds and looks good! For the frame rails, Semi Joe on Ebay sells different lengths and pre drilled for the King Hauler and others. (uncoated in silver look) When I post about him I seem to get grief from others, but I've dealt with him many times and no problems on my end. Check him out, makes life easier. Looks like your about 2" too long.
|
#36
|
|||
|
|||
![]()
Ok I'm moving the front axle, but once I try to move it the front dampers wont mount. Are they ditched?
__________________
Not trolling anymore... To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#37
|
|||
|
|||
![]()
Got it forget it lol
__________________
Not trolling anymore... To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#38
|
|||
|
|||
![]()
get rid of the dampers
![]()
__________________
René ____________________________________________ To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. ____________________________________________ |
#39
|
|||
|
|||
![]()
I got it to work. Here is how it sits. Yeah my livingroom is my work area lol
![]() Goal is to have the truck done by Cabin Fever 2016. So I can attend my first show with at least a working rig.
__________________
Not trolling anymore... To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Last edited by Kausekaos; 11-06-2015 at 05:33 PM. |
#40
|
||||
|
||||
![]()
nice mods, so far
__________________
all the DEDICATED Members will be there. the hobbiest formally known as Sweet Pete Wrecker, Founding Member of the East Coast Mini Truckers. |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|