|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
06-03-2011, 08:26 PM
|
|||
|
|||
a
Last edited by bigpipespete; 06-15-2011 at 02:07 AM. 
|
|
#3
06-03-2011, 10:37 PM
|
|||
|
|||
|
Re: bruder excavator
n.
Last edited by bigpipespete; 06-15-2011 at 02:07 AM.
|
|
#4
06-04-2011, 04:25 AM
|
||||
|
||||
|
Re: bruder excavator
Your picture's may be too big post, if you resize them to a lower resolution, they will post, or set up with photo bucket or one of those service's.
Just a few links for this site and scale 4 x 4, hopefully this help's you out! http://rctruckandconstruction.com/sh...uder+excavator http://rctruckandconstruction.com/sh...uder+excavator http://www.scale4x4rc.org/forums/showthread.php?t=60337 http://www.scale4x4rc.org/forums/showthread.php?t=58009 http://www.scale4x4rc.org/forums/showthread.php?t=54121 Later, Neil#2 aka doodlebug. Last edited by doodlebug; 06-04-2011 at 04:38 AM. Reason: more stuff
|
|
#5
06-04-2011, 10:56 AM
|
||||
|
||||
|
Re: bruder excavator
I'm sure that you have seen my thread on the excavator.Far as the turntable and tracks. I give a link to towerhobbies where I found the spur gear,its plastic,but a good grade,haven't had any problems with it other than a little sand getting in the teeth,I blow it out with air from time to time.Using a metal pinon gear on the servo.no problems with it.The way the model is made, thats the only way I could think to do the turntable. Cutting out the gear to fit.
Far as the tracks i'm pleased with servo ran.100 oz or more recommended. Hope this helps.
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
