|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hydraulic Oil for Wedico 740 ADT
I had the back of the hydraulic pump resevoir pop off, because the pressure relief line was plugged. Was wondering what type of oil I can use for this system?
Albert PS: I have ordered oil from Rick but was wondering if can find something similar in my local auto store. |
#2
|
||||
|
||||
Re: Hydraulic Oil for Wedico 740 ADT
Albert
I have switched over to jack oil and it seems to work just fine. I get it from Canadian Tire, easy to get and the price is right...hahah Would you happen to have any used 8 channel fm RX ? greg Last edited by RCLogger; 03-28-2011 at 10:06 PM. |
#3
|
||||
|
||||
Re: Hydraulic Oil for Wedico 740 ADT
I've been using Esso Hydraul 50 (10W hydraulic oil).
Did the previous owner cap the vent holes atop the reservior prior to shipping it to you? There's two vents on top of the tank that need to be open.
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
#4
|
|||
|
|||
Re: Hydraulic Oil for Wedico 740 ADT
Yes. Both capped. Ric from PMD said that only 1 has to stay open. So both open?
Last edited by aseejr; 03-29-2011 at 06:45 AM. Reason: spelling |
#5
|
||||
|
||||
Re: Hydraulic Oil for Wedico 740 ADT
I'd recommend both be open. To have only one open, too much air trying to escape through one small hole might cause some oil to blow out too.
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
#6
|
|||
|
|||
Re: Hydraulic Oil for Wedico 740 ADT
Thanks for the replies guys!!!
Albert |
#7
|
||||
|
||||
Re: Hydraulic Oil for Wedico 740 ADT
Quote:
Jordy |
#8
|
|||
|
|||
Re: Hydraulic Oil for Wedico 740 ADT
Quote:
Just tried it last night. So far so good. Everything is working. Now if I can only get the front tires to stay mounted on the wheel. Albert |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|