|
|
|||||||
| Mechanical tech This is for the mechanical parts of a model. Gear reductions, Axles, Transmissions, General drive line |
|
|
Thread Tools | Display Modes |
|
#3
02-19-2014, 04:46 PM
|
||||
|
||||
Re: Reduction question(again)
Increasing input speed to a gear reduction will not change the amount of torque out put. You have four times the torque out VS in . if you are spinning it at 1 rpm or 1,000 rpm torque is constant. Go faster? Yup. Stronger? Nope.
I've never seen it done but you could have a GRU before the tranny and another going out? Both available at PMD. I have 2 output types and they work great. Mario 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode