|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#3
04-28-2011, 03:05 PM
|
|||
|
|||
Re: Leimbach pump tip
I believe they use standard o rings as shaft seals. They are not particularly good and I have the same problem on my diy pumps. I changed to proper shaft seals and have not had a problem since. They will wear of course but are better designed for the job. I think the Leimbach has a small shaft 3mm? so finding seals for this size might be difficult. Lots of people also crank up the pressure and this is the result as well.
Iain 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode