|
Farm Tractors and Implements Discussion of farm equipment |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Scratch building a folding disc
I finally got a enough materials collected to start my latest build- a folding disc. If this is anything like the New Holland conversion i did it should take about 2 years too complete. First i started out with 3/16" x 3/4" aluminum strips to build the uprights that hold the row of disc. In the drill press had to make 16 pieces.
Next i pressed a bearing into cause i want this disc to last a long time. Next I took some 1 1/4" fenders and tapped the with 1/4 x 20 tap. Next threaded them on some 1/4" x 20 rod sharpened the edge on my bench ginder. stock washer vs sharpened one Ok i have 80 of these washers to due today. So tomorrow I'll post picture of a assembled row of disc. Time to get back to the ginder. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|