|
|
|||||||
| Metal forming & tools If it bends,twists,welds,cuts & turns metal.Post it here |
|
|
Thread Tools | Display Modes |
|
#2
05-09-2013, 02:47 PM
|
||||
|
||||
Re: Drill press fixture question...
Since you said its a cheapy I'm not sure it has a gib that presses against the dovetail, but you might want to try tightening those 3 screws. Those are usually gib screws and it should take the play out of each axis. See: http://www.mini-lathe.com/reviews/La...g_C8/gib02.JPG
Hope this helps.
__________________
Brian Finster shavin' and smokin' a cigar?!?! Last edited by Finster; 05-09-2013 at 02:51 PM. Reason: typos 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode