|
Big Boys of the road 4x4/6x6/8x8/10x10 Trucks This forum is for those multiple axle trucks and other vehicles on and off road. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Re: Custom Peterbuilt Dumper
Some more progress:
Front axle and steering mounted and working. I had to notch the frame for the servo ball connection so it could move to the right at 45 degrees: Rear axle Locker servos mounted and connected, minor frame notches to clear the servo travel here as well. I have decided not to servo control the front locker, but it can be added later if I need it. Tight squeeze, but the driveshaft clears the locker servos with a little room to spare: Also the power switch and charge jack mounted. Reg has finished my dump box and it's now at the powder coaters, so hopefully I'll have it in a week or two. Thanks again Reg, you have done an outstanding job on my dump box design and I would not hesitate one second in recommending you to anyone needing any fabrication work or a custom body built. John Last edited by JohnStilwell; 01-15-2014 at 03:57 PM. |
Currently Active Users Viewing This Thread: 4 (0 members and 4 guests) | |
|
|