|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
360 servo creeping
So I have converted my first servo ( hitec 325hb) to 360 rotation by taking out the pot and replaced it with 2 resistors of the value. It works well but a little hard to center or stop, I can deal with that. The problem is when I turn it off and then back on to use it again it starts turning slowly. I can us the trim to stop it but just wondered if I missed somthing ?
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|