|
General Discussion A place to post off topic discussions. |
|
Thread Tools | Display Modes |
#5
|
|||
|
|||
Re: Servo for raising / lowering tamiya landing legs
Pull the gears, remove the stops, done. The pot and circuit board get removed, then wire direct to the motor...continuous rotation servo. I've made them for my crawlers that way, but the motor is controlled via 3 way switch (fwd,neu,rev) on the radio going through a winch controller.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|