|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#21
11-05-2015, 12:49 PM
|
|||
|
|||
Re: Magom Brushless Pump
Hard to bleed the lines I found. What I did was have the excavator on the work bench then kept the bucket as low as possible over the edge. Idea the air flow to highest point which was the valve block and pump.
Not certain if air would go back through the oil like that but was only logic I could apply. Last edited by Digger_Bear; 11-05-2015 at 12:50 PM. Reason: Posted too soon 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode