Great Dane excavating co.

[Cooper]

Well I think this "plan" is going to work. I will have 1/8" clearance between axle and wheel hub body. I wanted a little more but it will work. Probably close to scale anyways. . I still have to drill out correct size on hub assembly and shorten shaft part. That part that started square and ended up round for the motors to slide in was about 2 1/2 hours. Set up and slow on the turning as I didn't want it to fly out of lathe. I'm going to drill new bolt holes in end carrier housing of gear head. Center has more meat in it. And the way I figure that part should be the weakest link but still a lot of aluminum for strength. Probably way more than needed but hey I got to get the weight up for that bet!!! Oh and all your guesses are locked in but I still keep the ability to change mine,,,, haha,