Liebherr R984 1:14

[tessen]

thanks for comment
i progress too slowly, now i´m making the hydraulic valve block i hope to share the test soon

Lil Giants: cycloidal reduction have many advantages, some are:

- if you turn the output axis, the input axis can´t be move (brake system)
- there are more surface in contac--> can manage bigger loads
- the output axis have a big diameter

in the video there are 2 stages of 1:10 (total 1:100) but this is a first test, now i have 2 stages of 1:15 (total 1:225) in the same place (and could increase the final relation) to obtain this is complex with spur gears (but i don't say you that it can't be done)

on the negative side this gearbox are difficult to machining, nevertheless i´ll i use it on the chain and in the turret turn

regards