|
|
#11
04-27-2017, 04:10 PM
|
||||
|
||||
Re: LilGiantsConstrCo
Me too Mark... almost there
 Went to town early this morning to use a welding shop's hyd roller bender to curve 1" square tube   Over did the back side a lil bit    A couple of empty test runs with the 4206 & trl, a lil hairy going off the back side... some asphalt shingles might suffice. Just gotta wire up the crusher, but 1st I need a nap! 
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
| Currently Active Users Viewing This Thread: 8 (0 members and 8 guests) | |
|
|
Threaded Mode