First attempt at lights

[frizzen]

If i'm reading their engrish correctly, it's more like a "Battle Switch" than just a light controller.

I have No Clue what they mean with 3 switchable modes.

It's needing the switched power input on the Female plug. It can work with 2.5v to 25v.
Led power output is on the male plug.

Run jumper wire from RX lead black wire to Female jst black, and another RX red to Female jst red.

Then throw a "current limit resistor" on one leg of Male jst before you solder up your leds. If you just tap Rx volts, 100 to 400 ohms should get you lit without smoking the led.

Check out me 'LED Lights for the Back of the Class' thread, it may answer some other stuff.