|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
#22
|
|||
|
|||
Re: Build an Excavator from Scratch
Todays work was a repair of the stick cylinder. Before the final assembling i've made the mistake to pull the rod complete to the end. During normal operations this never will happen due to the geometry of the stick.
At the end of the cylinder the piston collides with the oil input flange thereby the piston seals get damaged To open the cylinder i have to loosen the head. Sealed with loctite 542 thread sealant it just needed some hot air After replacing the piston o-rings and refilling the oil then thread sealant is applied Now I have to wait 24 Hours before the glue is cured.
__________________
Regards Ralf |
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
|
|