![]() |
|
Truck Building Tech Covers mechanical and electrical components for truck modeling |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]()
I figured i would challenge myself again and make some cb antennas for my girl and i think i didn't do too bad on them.
This is what i started with 2, 1/25 rear axles from and old kit i had. ![]() These are the antennas i have on truck now ![]() I then did the measuring with the other antenna and the pin in the end of cut my 2 metal axles to fit. ![]() Once cut and fitted i wrapped telephone wire aound the axle with the coating on it first, but found it was easier without the insulation on it just use the bare wire. ![]() After wrapping the wire i used 3/32" Tech-Tron Heat Shrink Tubing TT100 3/32" Blu to cover it and a lighter to shrink it and here are the results. ![]() ![]() ![]() ![]() ![]()
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
Currently Active Users Viewing This Thread: 6 (0 members and 6 guests) | |
|
|