Volvo EC300D

[RCP57]

Originally Posted by modelman

Very nice work! Would you show a picture of the slip ring?

The slip-ring isn't pretty(neither are the photos). I put 4 grooves in some nylon on the lathe and then wrapped each wire around agroove and soldered it. The wire coming out of the bus bar is stainless filler rod(very stiff) so I made a plexi block to isolate the wires and attached 2 springs to the block for tension. I'm sure there is an easier more effective way to do it but I had all these things in my junk so...

Reg