|
|
|||||||
| Metal forming & tools If it bends,twists,welds,cuts & turns metal.Post it here |
|
|
Thread Tools | Display Modes |
|
#9
09-07-2010, 09:24 PM
|
|||
|
|||
Re: Help with a bandsaw
The dimmer switch sounds interesting, but is it a regular light dimmer? Seems that wouldn't be able to handle a motor.
I'm no bandsawologist, but from what I gathered, the blade moves too fast, which cutting thinner metal somewhat proves to me because then it goes nice and straight. I did play around with adjusting the blade and double checking setup procedure according to the manual for an hour plus when I went up and got a thinner piece of metal which it cut nice and straight through. I don't remember the thicknesses, but lets say 1/16 and 1/32. I'm thinking too I should forget about steel and just cut alu on this, but I would really like to be able to cut 1/16 steel.
__________________
Call me Thor, it's short for Thorsteenster. In VA? Check out To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Last edited by Thorsteenster; 09-07-2010 at 09:35 PM. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode