|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#8
07-10-2012, 05:01 PM
|
|||
|
|||
Re: Hydraulic Question
Just done calculations based on a 16mm cylinder at 17bar is around 35kg force, that seams good enough and 20mm is around 54kg, like it
I will pm you the link for the machining company, Also got a quote to cut all the parts out of 3mm ally for around £300 each model, assuming i can fit it on an 8x4 sheet Adey Where abouts are you based? 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode