|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
#6
|
||||
|
||||
Re: Stahl 922 help
That's Liembach's esc, it always works in mix mode, can't turn it off for individual ch function like the choice you'd have with a Sabertooth.
I'd move from Aux 1 to Aux 3 so the knob will give proportional control for/rev. Then Aux 2 used for steering. With the 3pos switch centered on Aux 2, it should drive straight, and up or down should steer lt/rt... is it doing that? I was using some 9amp Banebot esc's for pump control, but Robotmarketplace no longer can get them. But this one from E-flite seems to be a suitable replacement and even has a lipo cut off should you choose to use one... although the lower voltage of 9 to 12.6 will slow down the hyd speed vs a 10 cell @13.4v fully charged. http://www.robotmarketplace.com/products/0-EFLA105.html Then setting up the mix on the radio is super simple & will extend batt run times greatly not having the pump run wide open all the time.
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|