|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
|
Thread Tools | Display Modes |
|
#15
06-14-2013, 03:24 PM
|
||||
|
||||
Re: Conveyer Build
Well, no two tubes the same with the mold lines to use as a cutting guide... one belt is 69mm, another is 72mm... that I recall off the top of my head. I measure throughout the entire length to find the widest area, the cut varies 1 - 2mm in width... not perfectly true, but that shouldn't pose any problems.
Tight enough that I could probably play a tune from it.  If the bearings I got fail, then I'll install bigger bearings. 
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode