|
|
|||||||
| Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models. |
|
|
Thread Tools | Display Modes |
|
#28
09-27-2013, 01:20 PM
|
||||
|
||||
Re: He is at it again! 1:50 Dozer Conversion
Started working on the track upgrade yesterday. I'm drilling out the cast pins and thru both part. Then 1/16" piano wire goes in place. The two pictures show the slop due to wear of the pins cast on the original pads. I was able to remove a complete link and get the track back on, it was too tight though and I didn't run it that way.
  The short top section is what I have done so far, just started. Jim Last edited by Rvjimd; 09-27-2013 at 01:22 PM. Reason: More 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode