|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
|
Thread Tools | Display Modes |
|
#7
05-22-2015, 10:24 PM
|
||||
|
||||
Re: Dragline Crawler Build
Tom, the stock is 1/8". I WAS experimenting with 1/4" stock where I machined the dogs on the one side but that was a lot of extra work. With the current pads pictured I am milling the leading and trailing edge hinged slots as well as the short slot on the one side to accept the little channel part that becomes the drive dog. I hope that clears it u a bit?
Jim 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode