Another Bruder Mack conversion

[Darrin]

Very nice job on the bruder I will try to build one in the near future love the videos on it.

[RCP57]

Originally Posted by Bouge78

Hi Reg,
just wondering what brand of 360 servo you used on the lift? also, how did you wire up four motors to one esc?
great build mate!
cheers
ben

Sorry I missed this until today Ben. This is the servo I used. https://www.pololu.com/product/1248 They are fairly cheap but seem to have good electronics and enough torque. They have a center point adjustment and rarely creep once adjusted. I have tried 360 servos from Towerpro on something else and I couldn't get them to stop creeping. I wired the four motors together but one side of the truck needs to have the polarity reversed. Works just fine!

Originally Posted by Darrin

Very nice job on the bruder I will try to build one in the near future love the videos on it.

Thanks Darrin. Good luck with yours!