|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#2
11-13-2015, 04:38 PM
|
|||
|
|||
Re: plumping !
Hi, no it doesn't matter what goes where, just as long there are 2 hooked up lines between cylinder and valve. One can then reverse the servoes at the radio later, as needed. Likewise with the pump and tank lines into the end of the valve block, choose left or right channel freely
It's advisable to use thread sealant Locktite 542, or similar, on all threaded fittings. Last edited by Rimrock; 11-13-2015 at 04:41 PM. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode