RC Truck and Construction  

Go Back   RC Truck and Construction > RC Tech section. > Electronics tech
Reload this Page setting up transmission positions
Register FAQ Calendar Search Today's Posts Mark Forums Read

Electronics tech Anything to do with the electronics in a model. Lights, Radio, ESC, Servo, Basic electrical.


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #4  
Old 03-13-2016, 04:03 PM
fhhhstix's Avatar
fhhhstix fhhhstix is offline
Out of control
  
Join Date: Aug 2010
Location: Kirklin IN.
Posts: 3,788
fhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud of
Default Re: setting up transmission positions
Quote:
Originally Posted by stephenk99 View Post
hi

thanks for reply but not as simple as moving end points with the mfu 03 wish it was all the adjustsments are done through a transmission learning routine !!
Sorry I did mis the 03 part and yes it has to be done in the programing section of the trans in the mfu. I did mine in the Cascadia just make sure you have the endpoints set to %100 or it will not calibrate
__________________
AKA "00" Biddle


RIP FreddyGearDrive 2-12-59/12-19-11
Reply With Quote
 

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 05:06 PM.

Contact Us - RC Truck and Construction - Archive - Top

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.