How To Custom Drive Shaft - RC Truck and Construction

		RC Truck and Construction > RC Tech section. > Mechanical tech
How To Custom Drive Shaft

Mechanical tech This is for the mechanical parts of a model. Gear reductions, Axles, Transmissions, General drive line

Thread Tools

Display Modes

01-24-2017, 11:22 AM

scottyk

Newbie

Join Date: Jun 2013

Posts: 112

Re: How To Custom Drive Shaft

So are you guys drilling a hole thru the steel shaft and using a traxxas pin instead of a set screw? I just cant picture a plastic driveshaft yoke being strong enough to tighten a set screw against the flat on the steel shaft, steel shaft being the pinion bearing or transmission output.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 6 (0 members and 6 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 05:09 PM.