|
|
|||||||
| General Discussion A place to post off topic discussions. |
|
|
Thread Tools | Display Modes |
|
#11
01-31-2017, 04:59 PM
|
|||
|
|||
Re: Eagle Mach JD-98/RC4WD DXR2
Started getting into checking fixtures and screws. The fixture on the fill lead was loose. Also started filling the tank and had oil spill out everywhere from the "relief" hose. Only had about 100ML in so guess it had some residual in the tank from functions testing at the factory. Going to replace that with a vent I have left over from a 4200 tank replacement.
fill line is on the left, relief line on the right. May be a couple days before it gets in any dirt.    
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode