|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
06-18-2017, 01:49 PM
|
||||
|
||||
tubing?
Hi, what are you guys using for hyd tubing on your scratch builds?
I purchased some from local truck parts dept. that is used for air line to shifters etc on the fuller trannies, it does bend with a little heat from a heat gun but then becomes very hard after cooling, I tried warming it in hot water, will then bend but retains bend after cooling. Thanks Terry 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
