CAT 14M3 Motor Grader

Tunnelmaynia · #1 12-10-2018, 03:52 PM

Hemi1966
Thank you for the reply. I hadn't thought about scaling up. I was afraid of the dimension from the smaller die-cast models being to far off. I will give it a go and start drawing some things and assembling the 3d components in fusion. Thanks again.

Hemi1966 · #2 12-11-2018, 10:53 AM

Quote:

Originally Posted by Tunnelmaynia

Hemi1966
Thank you for the reply. I hadn't thought about scaling up. I was afraid of the dimension from the smaller die-cast models being to far off. I will give it a go and start drawing some things and assembling the 3d components in fusion. Thanks again.

Dimensions of smaller details that are impossible to cast in small scale might be slightly off, but most dimensions are correct enough.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 3 (0 members and 3 guests)