|
Highway Trucks and Trailers On road trucks and trailers single and twin axle trucks. |
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
Re: Hobbs Reefer From a Tamiya Semi Trailer
Are you going to fit a mfu in the cab, I’m a long way off yet but I have all the parts, just need to figure out how to cut the cab up and shorten it.
|
#22
|
|||
|
|||
Re: Hobbs Reefer From a Tamiya Semi Trailer
i think i'm going beier instead. i trying one of their units now on another project. **** that sucks on the rc4wd front. keep an eye on ebay, bound to pop up from a chinese knock off.
i think i got the sleeper shortened pretty good.. still need to fill the roof a bit Last edited by bigdogrod; 07-17-2019 at 08:30 PM. |
#23
|
|||
|
|||
Re: Hobbs Reefer From a Tamiya Semi Trailer
Looks amazing, I love the rounded corners on sleeper looks perfect, I will post my progress as I go thanks again
|
#24
|
|||
|
|||
Re: Hobbs Reefer From a Tamiya Semi Trailer
3D printed wheels are available here : Shapeways/SmallScaleModelCollection/Wheels
|
#25
|
|||
|
|||
Re: Hobbs Reefer From a Tamiya Semi Trailer
My trailer arrived today, can’t believe how heavy it is, been looking at how to move wheels back, looks pretty simple, but my question is did you lengthen the two shocks at the back of the trailer and what did you use if so ?
|
#26
|
||||
|
||||
Re: Hobbs Reefer From a Tamiya Semi Trailer
Quote:
2/ The Dayton look is created with styrene. I glued chopped rectangular pieces onto a styrene disk. The center is large enough to fit a nut driver onto the hub nut. 3/ Also from Garden Trucking https://www.gardentrucking.com/ |
#27
|
||||
|
||||
Re: Hobbs Reefer From a Tamiya Semi Trailer
Nice work
|
#28
|
||||
|
||||
Re: Hobbs Reefer From a Tamiya Semi Trailer
Well job, i like the rims
|
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
Thread Tools | |
Display Modes | |
|
|