|
|
|||||||
| Truck Building Tech Covers mechanical and electrical components for truck modeling |
|
|
Thread Tools | Display Modes |
|
#25
08-31-2022, 09:37 PM
|
||||
|
||||
Re: Axle suggestions?
I remembered the Redcat Everest-16 rock crawler that was a donor for my Structo Dump originally had a 280 / 370 motor. So ordered pair of Redcat 'RC370' 28026N motors.
 Redcat motors are a direct swap into those jsx-370 series gearboxes. Screws were originally installed with very much red locktite, assume the need for heatgun or soldering iron to break hardware loose. Brass worm gears are a press fit on rotors, but you can lever them off the original motors with Diagonal cutters. Uh, gear ratio is probably WAY off. But i'm learning. Maybe?
__________________
What do ya mean "Cars are neither Trucks or Construction"? It's still scale, and i play fairly well with others, most of the time... Last edited by frizzen; 09-02-2022 at 11:49 AM. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode