1/10 Mining Dump Truck

[pufferfish]

Hi there,

some months later......
(during them i've built a 1/10 stainless steel land rover forward control)
....... the dumper needs an improvement of his drive train.
fully loaded it was a bit weak.
After a detail research i've found some issues. The rims are able to get contact with the axle and the motors don't get enough power to work properly.

First attempt to seperate rims and axles are a gliding tape glued onto the axles. Unfortunately works is not good.

Second attempt are these brass rings with the function of very small bearings.





After a couple of new escs i've found the working solution with seperate hobbywing 1080 for each motor.

Now the dumper can work in soft and hilly terrain too.



traces in the sand (including a footstep in size 16)