|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
|
Thread Tools | Display Modes |
|
#11
09-29-2011, 08:20 AM
|
||||
|
||||
Re: D11 New Project
Any thought of adding a full radius keyway cutter to your 1st op on the track links so you don't have to mill the inside ends of the track links for clearance in a 2nd op?? Like I said, I have been running 4 axis Okumas for over 20 years and know a lot of short cuts!! Also, you might want to look into fine-tooth roughing cutters to hog out most of the material on the track plates. Looks like you used 1 on 1 end of a track plate??
Just some ideas 
__________________
LYNN 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode