U BOLTS

[dabears]

Originally Posted by ihbuilder

macmasterCar

brass 3mm rod

standard brass rod you want .114"

little trick chuck your piece of rod in you drill (hand) , taper end slightly , dip in tapping fluid , and ( in low speed ) thread away to desired length and rev. drill .125 rod is to big , It'll werk but tends to slip in the drill chuck .


3.0000 mm = 0.1181
1/8" =.125

That helps me out. not sure if it helps Big John out. Not sure his question was ever answered as to if anyone knew where to buy pre made ones.