Volvo G990 Grader

[Stefan]

Can sure agree on that. I actually calculated and marked the length to cut before bending. The first cut was just a bit too long (and luckily not too short).

[9W Monighan]

Originally Posted by Stefan

Can sure agree on that. I actually calculated and marked the length to cut before bending. The first cut was just a bit too long (and luckily not too short).

If you think on the lines of the neutral axis of the piece your cut length will come out close plus the flat material on the ends . When you bend something, the outside area is stretching and the inside area is compressing. When we bend and cut an arc we calculate the circumference of the web were we can wrap a tape ruler around and cut to size.